Malloca MST 35-IX03, Instruction Manual

Page: 13 / 15

13
standby state).

Press “ ” start/pause button, digital tube display “PUMP IN” said back extraction system
open

When “0.5L” appears, that shows you should add 0.5 L descaling solution to water box.

Press “ ” start/pause button to start descaling function, it will take 30 minutes.

When “1.0L” appears, that shows you should add 1.0 L cold water to water box.

Press “ ” start/pause button to start program, when “CAL END” appears that shows
descaling function is end.

When open the door or press “ ” start/pause button, prototype into standby mode.
Time interval of descaling depends on Hardness of water and frequency of use.If every week
use steam function 4 of x30 minutes, in order to extend our steam furnace life, we suggest you 6
months after a scale removal function.
Note : In the descaling function before water in boiler is empty to smoke; If the boiler inside still
withhold water inside, in the operation scale removal function of time, the program can't normally
open.
14
、
CLEANING AND MAINTENANCE
Before cleaning your oven or performing maintenance, please cut off the power supply.
In order to prolong the service life of steam oven, please note the following points
：

The enameled or stainless steel parts should be washed with lukewarm water without using
any abrasive powders or corrosive substances which could ruin them ;Stainless steel could
get stained .If these stains are difficult to remove, use special products available on the
market. After cleaning, it is advisable to rinse thoroughly and dry.

The inside of the oven should preferably be cleaned immediately after use, when it is still
warm, with hot water and soap; the soap should be rinsed away and the interior dried
thoroughly. Avoid using abrasive detergents (for example cleaning powders, etc) and abrasive
sponges for dishes or acids (such as lime scale –remover, etc„) as these could damage the
enamel .If the grease spots and dirt are particularly tough to remove, use a special product for
oven cleaning, following the instructions provided on the packet. Never use a steam cleaner
for cleaning inside of oven.

Suitable for descaling of cleaner, such as liquid coffee machine descaling cleaner. Share not
with foam cleaner.

Avoid using grinding sand mold cleaner, such as wash mat, steel wire ball, etc, may damage
the surface

Important: please don't water tank in the dishwasher cleaning.
Replacing the oven lamp:
1
）
Disconnect the oven from the power supply by means of the Omni polar switch used to connect
the appliance to the electrical mains ;or unplug the appliance if the plug is accessible ;
2
）
Remove the glass cover of the lamp-holder ;
3
）
Remove the lamp and replace with a lamp resistant to high temperatures with the following
characteristic.

Voltage
：
220-240V

Wattage
：
25W

Type
：
E14