The panels of the adjacent cabinets must be made of heat-resistant material. In particular, cabinets
with a veneer exterior must be assembled with glues which can withstand temperatures of up to 100
℃
.
In compliance with current safety standards, contact with the electrical parts of the oven must not be
possible once it has been installed.
All parts, which ensure the safe operation of the appliance, must be removable only with the aid of a tool.
11
、
APPLIANCE CONNECTIONS
11.1 Fitting on a Power Supply Cable
Those ovens equipped with a three-pole power supply cable are designed to operate with an alternating
current .The wire for earthling the appliance is yellow-green in color.
Opening the terminal board:
· Using a screwdriver, prize the bolt on the side tabs of the Terminal board cover;
· Unscrew the bolt, pull open the cover of the terminal board.
To install the cable, proceed as follows:
· Remove the wire clamp screw and the three contact screws L-N -
· Fasten the wires beneath the screw heads using the following color scheme: Blue (N) Brown (L)
Yellow-Green
·Fasten the supply cable in place with the clamp and close the cover of the terminal board.
·The ac power supply should be 240V, 50 Hz, the minimum 15A distribution circuit fuse, or at least 15A
distribution circuit breaker.
11.2 Connecting the supply cable to the mains
Install a standardized plug corresponding to the load indicated on the data plate. When connecting the
cable directly to the mains, install an Omni polar circuit breaker with a minimum contact opening of 3
mm between the appliance and the mains .The Omni polar circuit breaker should be sized according to
the load and should comply with current regulations (the earth wire should not be interrupted by the
circuit breaker).
The supply cable should be positioned so that it does not reach a temperature of more than 50
℃
with
respect to the room temperature, anywhere along its length, or protected by insulation sleeping having an
appropriate rating.
Before making the connection, check that:
· The electrical safety of this appliance can only be guaranteed if the cooker is correctly and efficiently
