Malibu Boats 2009 21 vRide, Owner'S Manual

Page: 60 / 132

2-30
The START LED will blink if entered code is valid. If code is invalid, START and STOP
LED will blink alternately 3 times and start over again from step 1.
Step 2:
Enter the new 4 to 8 digit ACCESSORY code then press START. START and
STOP LED will light for 1 second followed by a blinking START LED to indicate code
needs to be validated by re-entering the same code again.
Notice:
ACCESSORY code must be different from the USER code.
Step 3: Enter again the new code then press START. If system recorded twice the same
valid code, STOP LED will light steady and Keyless Ignition will be in ACCESSORY
mode. If codes are not valid, START and STOP LED will blink alternately 3 times. Start
over again from step 1.
Backlight Intensity Adjustment
Backlighting intensity of the keypad can be adjusted to individual owner preference using
the “2” and “4” buttons when system is in STAND-BY mode or engine is running. Press
the “2” button to increase backlight intensity. Press the “4” button to decrease
backlighting intensity. Each step increases/decreases intensity by about 5%. Holding one
of the buttons depressed will automatically ramp up or down intensity until button is
released. Backlight setting will be memorized in the system’s non-volatile memory.
MUX Switch
The 2009 Malibu system comes with three different MUX switch modules: one on the
left that has the HORN button; one on the right that has the STEREO buttons; and an
optional one for the back that has the STEREO buttons.
These modules have the ability to have any function added, subtracted or moved. This
makes the boat a lot more flexible when adding or deleting options from the switches.
The MUX switches are connected to the boat and POWER module by the CAN BUS. If
CAN communication is lost between it and the POWER module, the MUX will display
last known output state.
The MUX switch indicates the current status of each switch, so that if the MINI activates
one of the ballast fill pumps, the MUX switch will show FILL on that tank.
The MUX is designed to stay active for 30 minutes after ignition is off and all switches
are off.
The MUX switch will wake up anytime a button is pressed with ignition off.
The Vertical button is called the PAGE button. It allows the user to toggle through the
menu to buttons on other pages.
Chapter 2_09.qxd: Chapter 2 doc.qxd 10/7/08 3:10 PM Page 30