malema.com
FLOW SETTING
The flow setting is adjustable. This is achieved by means of the setscrew. By turning the set-screw clockwise, the flow setting
would be decreased, and by turning it counterclockwise, the flow setting increases.
07
Malema Sensors warrants to the buyer that its products are free from defects in materials and workmanship at the time of
shipment and during the WARRANTY PERIOD. Malema Sensors obligation under this warranty is limited to the replacement of
the product(s) by same product(s) manufactured by Malema Sensors or repair of the product(s) at the Malema Sensors facility.
Malema Sensors products are sold with the understanding that the buyer has determined the applicability of the product(s)
to its intended use. It is the responsibility of the buyer to verify acceptability of performance to the actual conditions of use.
Performance may vary depending upon these actual conditions.
Warranty Period
This warranty is in effect for twelve (12) months from the date of shipment from Malema Sensors place of business.
Warranty Claim
If Malema Sensors products are found to be defective in materials or workmanship within twelve (12) months of the date of
shipment, they will be repaired or replaced with same product at the discretion of Malema Sensors at its place of business at
no charge to the buyer.
Return
To return the products, please obtain an RMA number for the product by contacting Malema Sensors (Corporate Office), Boca
Raton at (800) 637-6418 or (561)995-0595.
All returns of equipment must go to the following address:
Malema Sensors,
1060 S Rogers Circle
Boca Raton, FL 33487, USA
Warranty
Note:
The flow switch performance will be affected in the vicinity of Magnets, Electromagnets, and Ferrous metals. Hence
adequate protection should be provided while installing in close proximity to such interferences or relocate the flow
switch away from them appropriately.
Ordering Information
Standard Part Numbering
M
-
Model
-
Material
Port
Switch
M
-
200
-
S
1
1
200
A - Aluminum
B - Brass
P - Acrylic
S - 316 Stainless
T - PTFE
3 - 3/8”
4 - 1/2”
6 - 3/4”*
1 - SPST N.O.
3 - SPDT
* The M-200 with 3/4” ports is ONLY available in the Brass, PTFE or 316SS body material.
The M-200 in Brass or 316SS is also available with SAE8 ports.
NOTE: Specifications are subject to change without notice.
© 2018 Malema Engineering Corporation. All rights reserved.
Malema Sensors® is a registered trademark of Malema Engineering Corporation. Malema, the Malema logo, and Malema Engineering Corporation are trademarks of Malema Engineering
Corporation. All other trademarks are property of their respective owners.
Malema supplies this publication for informational purposes only. While every effort has been made to ensure accuracy, this publication is not intended to make performance claims or
process recommendations. Malema does not warrant, guarantee, or assume any legal liability for the accuracy, completeness, timeliness, reliability, or usefulness of any information,
product, or process described herein. We reserve the right to modify or improve the designs or specifications of our products at any time without notice. For actual product information and
recommendations, please contact your local Malema representative.