O P E R AT I N G I N S T R U C T I O N S
14
Cleaning the Detergent Dispenser Drawer
When detergent builds up in and around the drawer, remove the
drawer by pressing on the plastic part of the softener compartment
marked “PUSH” (Fig. 10A). Place under running water for a few
minutes to remove buildup. Clean and wipe out the area around the
dispenser with a damp cloth before replacing the drawer.
Do not use liquid detergent for pre-wash because the detergent will
wash out of the drawer. Use only (HE) powdered detergent in the pre-
wash compartment.
Use low-suds high efficient (HE) detergent made for front-loading
washers. For HE detergents, use only 1 – 2 tablespoons. Too much
detergent can leave residue on your clothing and damage the washing
machine.
Do not use hand-washing detergent, as it may foam too much and
damage your machine.
Do not over use Fabric Softener. Use 1 to 2 tablespoons only!
Reduce the amount of detergent for cold water washing, as it
dissolves less easily in cold water.
Do not exceed recommended amounts of detergent and softener, as it
will result in poor washing and rinsing efficiency.
For (HE) liquid detergent use, refer to page 13.
Operation
Using Your Washing Machine
Operating your MALBER Washing Machine correctly affects your wash
quality and extends the life of the machine. Before using the
washing machine, make sure you are familiar with the proper load sizes
(See Load Types and Sizes, pages 11-12).
Add detergent and fabric softener according to directions (see Using
the Laundry Aid Dispenser, page 13), then check to make sure that:
tergent drawer is completely closed
ecurely in the electrical outlet
Water supply is on
achine door is closed securely
To start the Wash Program:
Set Wash Program Knob to the desired program for your current load
(see Guide to Wash Programs, pages 11-12).
Select the buttons whit the required functions.
Add appropriate amounts of HE detergent and fabric softener into
dispenser.
Press Start to begin the cycle.
Note
: For more information on correct use of controls, see
Understanding the Control Panel, page 8.
Note
: When using a liquid detergent (recommended for programs
without pre-wash) proceed as follows: remove the baffle from its
housing at the front of compartent 2 and insert it in the guides near
the centre of the same compartment (Fig.9A -Fig.9B). Close the
detergent drawer before starting the wash (Fig.9C).
To start the Wash only program:
(see wash programs, page 12)
Follow steps above.
Note:
At end of program, door lock remains engaged for 2 minutes,
after which you can open the door.
Reset Program / Add Garment
To stop the machine after a program has started, turn Wash Program
Knob to Stop. To restart the program, reposition the Wash Program
"To add a garment"
When you press this button, the light starts to flash.
It goes out after a few minutes, while when the Start light flashes this
indicates that it is possible to open the door and add more washing.
After closing the door again, press Start to continue washing.
The cycle will start up again from the point at which it had stopped.
The indicator light will stop flashing and remain fixed.
Knob and press Start.
Tips
Fig. 10A
O P
Use “Qu
Do not u
solvents
washed
Do not u
use for f
Do not u
the was
After yo
Takin
Exter
Wipe the
machine
cloth. Do
chemica
to clean
to allow
Coin
Clean th
times a
drained
door.
• Place
trap doo
water.
• Remo
slowly c
water ap
• Empty
Pull coin
clean.
• Replac
Gently tu
trap is s
clockwis
