A
FRAME AND RUNNING GEAR
DRAKON 50 NKD
1
6
03/06
SYMBOLS
• Symbols are provided for quick and easy reference (see the relevant heading), identifying situations requiring
utmost attention or providing practical suggestions or simple information.
• These symbols may appear next to a text (in which case they refer solely to the text itself), next to a figure (in
which case they refer to the topic illustrated in the figure and to the relative text), or at the top of the page (in which
case they refer to all the topics dealt with in the page).
NOTE
The meaning of the symbols should be duly memorised as their scope is to avoid having to repeat
basic technical concepts or safety recommendations. They are therefore to be considered as “memory
tags”. In case of any doubt as to their meaning, consult the page in which they are fully described.
ABBREVIATIONS
UNITS OF MEASUREMENT
All the dimensions in this Manual are shown in
mm.
NOTE
The letter V in the illustrations refers to fixing or adjusting screws. The number following this letter
refers to the number of the same type of screw in the unit or component described and illustrated. A
letter without a number indicates quantity 1. In case of different screws being referred to in the illustra-
tion, the letter V is followed by a number and a lower case letter. Example: (V4a).
Unless otherwise specified, units and components are reassembled by proceeding in the reverse or-
der of removal.
INTRODUCTION
F
Cs
P
Pr
S
Sc
T
V
Figure
Tightening torque
Page
Paragraph
Section
Diagram
Table
Screw
Summary of Contents for CNK 50 DRAKON
Page 1: ...FRAME AND RUNNING GEAR WORKSHOP MANUAL CNK 50 DRAKON ...
Page 2: ......
