20
The MIRA system can also be used together with a remote control for an even easier operation of the
measurement system, see Figure 3.12. Instructions in eight simple steps are found below.
Fig. 3.11.
The MIRA remote control, with three function buttons (Stop, New and Marker) and 4 LED
indicators. The two LED´s (1 and 2) indicates ongoing survey (measurement) with steady green light
and when blinking ready or stopped. The LED´s (3 and 4) indicates no connection or error with steady
or blinking red light..
Note!
The remote control should be connected prior the power of the MIRA antenna box is turned ON.
Note!
Whenever a button is pressed on the remote control, a beeping sound is heard.
1.
Connect the remote control
to the 15-pin DSUB connector on the outside of the MIRA
antenna box, see Figure 3.12.
Fig. 3.12.
Connection of the MIRA remote control to the MIRA antenna box.
2.
Connect
the remote control cable
between the ProEx AUX1 connector and the internal 15-
pin DSUB connector of the MIRA box. See Figure 3.13.
1
2
3
4
