
8
Remove the chip deflector.
Attach the straight guide with the clamp screw (A). Loosen the wing nut on the
straight guide and adjust the distance between the bit and the straight guide.
At the desired distance, tighten the wing nut securely.
When cutting, move the tool with the straight guide flush with the side of the
workpiece.
If the distance (A) between the side of the workpiece and the cutting position is
too wide for the straight guide, or if the side of the workpiece is not straight, the
straight guide cannot be used. In this case, firmly clamp a straight board to the
workpiece and use it as a guide against the trimmer base. Feed the tool in the
direction of the arrow.
Circular work
Circular work may be accomplished if you assemble the straight guide and
guide plate as shown in the figures.
Min. and max. radius of circles to be cut (distance between the center of circle
and the center of bit) are as follows:
Min.: 70 mm
Max.: 221 mm
For cutting circles between 70 mm and 121 mm in radius.
1. Clamp screw (A)
2. Straight guide
3. Wing nut
4. Base
1
2
3
4
004559
A
005437
1. Wing nut
2. Wave washer
3. Flat washer
4. Guide plate
5. Straight guide
6. Centre hole
7. Bolt
1
2
3
4
5
6
7
001993