6
Dispose the packaging in a sustainable
environmental way.
The miter saw is designed to operate indoors and
must be placed on a firm, stable and level surface, as
explained below:
Mounting on a workbench
The four legs of the saw have holes, as shown in
figure 1, to facilitate the assembly of the table. Always
assemble your saw by securing it firmly to prevent it
from moving. To improve the transport of your tool,
you can mount it on a piece of wood 13mm (1/2 ’’) or
thicker, which can be fixed on the raised support to
other work places.
NOTE:
If you are going to fix your saw on a wooden
plate, make sure that the screws will not go through
the thickness of the wood. The wood must be parallel
to the work table. When attaching the saw to any work
surface, use vise or sergeants and fix it only by the
feet where the screw holes are located. Attachment to
any other part of the saw may interfere with the proper
functioning of the equipment.
CAUTION:
To prevent the saw from becoming
move and cause lack of precision, make sure that the
table where the saw is supported is not uneven. If the
saw moves over the surface, place a support under the
base until the saw settles firmly on the surface.
Installing a New Blade on the Equipment
IMPORTANT: Remove the miter saw from the
socket.
Do not cut ferrous materials or masonry materials with
this miter saw.
With the saw arm in the raised position, raise the blade
guard as far as possible. Loosen (but do not remove)
the guard console screw, until the guard console can
be raised high enough to allow access to the blade
screw. The blade guard will be held in the raised
position by the console guard screw. Push the button
lock the shaft with one hand and use the blade wrench
with the other to loosen (clockwise) the screw in the
slot on the left side of the blade.
NEVER TIGHTEN THE AXLE LOCK PIN WHILE THE
BLADE IS SPINNING.
Be sure to hold the guard
console down and securely secure the guard console
screw when you finish installing the saw blade. Failure
to do so will cause serious damage to the saw and
possible personal injury.
NOTE:
There are two different cut diameters on the
inner plate, which have marked 25.4mm and 16mm.
When installed, the outer diameter of the inner plate
must correspond with the diameter of the saw blade.
To install, place the blade and screw. Press and hold
the shaft and tighten the screw in the opposite
direction of the cranks with the key, then tighten again
in the direction of the cranks (clockwise) with the metal
guard screw.
NOTE:
Only use the key that comes with the saw to
install and remove the saw blade.
Saw assembly and adjustment: Switch off the saw
before adjusting it.
Installing the square fastener button: Remove
plastic
bag square fastener button
Carefully screw on the arm located at the front of the
saw.
Dust Bag Installation
Your saw comes with a dust bag. To install the bag,
place the plastic opening in the dust extraction socket
of the tool.
The saw can be used with a suction hose fitted to the
machine's dust extraction support, or without any
device.
MAKE THE ADJUSTMENTS HAVING THE SQUARE
SAW DISCONNECTED FROM THE OUTLET.
NOTE:
Your miter saw was precisely adjusted at the
factory during manufacture. If it is necessary to
readjust according to the transport and
