10
press, a mold or any other element to prevent
movement during cutting.
Arched Material
When cutting a material that is arched, position it with
the hollow facing the front of the equipment, and never
facing the side guides. The incorrect position of the
material may cause it to tighten the disc before
finalizing the cut.
Cutting of Plastic Tubing and Other Circular
Cross-Cutting Materials
The plastic tubing can be easily cut with your saw, just
like cutting wood. For this, the material must fit firmly
against the guide in order to prevent its movement,
particularly when making angular cuts.
1. All fixed parts of the saw are sealed. They are
permanently lubricated and require no
maintenance.
2. Clean and remove all dust and wood chips from the
surroundings and under the base and rotary table
periodically. Even if there are consoles to allow that
waste to drain, there will be
3. the accumulation of dust.
4. The bushings are designed to provide several years
of use.
Important:
To maintain security and reliability
of the product, repairs, maintenance and adjustments
should only be carried out by authorized technical
assistance that will use identical parts for replacement.
Frequent Troubleshooting Guide Be sure to follow the
safety rules and instructions according to the table
below.
CAUTION: The use of any accessory not
recommended as a set for cutting channels, cutting
frames or discs abrasives, can be dangerous.
TECHNICAL ASSISTANCE
For your greater safety, entrust repairs, maintenance
and adjustments (including inspection and
replacement) to the technical assistance
recommended by MAKSIWA, which will always use
genuine spare parts and accessories, reassembling
your saw in the same way as the original.
The use of this tool for professional or industrial
purposes is not recommended by MAKSIWA. Before
using an extension cord, check for loose or exposed
wires, damaged insulation and defective fittings.
Repair or replace the extension if necessary.
Imported by Maksiwa USA Inc.
4100 N Powerline Rd, Suite D3 Pompano Beach, FL 33073
www.maksiwa.com
754-205-6717
MAINTENANCE
ISSUE
CAUSE
HOW TO FIX IT
Saw doesn't turn on
The saw is not connected to power
Connect the saw
There is a burned fuse
Exchange the fuse
The switch is open.
Close the switch
The wire is damadged
Exchange the wire at a authorized workshop
The coals have worn out.
Replace the coals at an authorized workshop.
Saw doesn't make
satisfactory cuts
The disc is not sharp.
Exchange the disc
The disc is mounted upside down.
Switch the position of the disc
The disc is dirty.
Take off the disc and clean it
Wrong disk for the job type.
Exchange the disc
Part is poorly fixed.
Fix the part properly to your saw.
The angle scale is not adjusted.
Check and adjust the scale.
The disc is not aligned with the guide.
Check and adjust.
The disc is not perpendicular to the table.
Check and adjust according to the instructions.
The moving work table.
Fit the workpiece to the guide.
The disc does not
reach working speed.
Extension cable too thin or too wide.
Replace with a suitable extension.
Dirt preventing movement of the disc.
Remove the disc and clean it.
The electric current is too low (oscillating).
Contact your power supplier
The machine vibrates
excessively.
Saw incorrectly attached to the table.
Check the assembly instructions.
Table or bench with uneven surface r.
Place the saw on a suitable surface.
The saw blade is damaged.
Replace the disc.
The material
damages the disc.
It is cutting arched material.
Place the part according to the instructions.
Material in disagreement with the instructed.
See instructions for materials.
