20
5. Place the new sandpaper and align it in the center of each shaft and tension the sandpaper by
turning the lever (A) of the figure above counterclockwise.
6. 6. Before reinstalling the items that were removed, the sanding centering should be checked and
adjusted if required. To do this, follow the instructions in the next topic.
7. 7. Reinstall previously removed items (Guards Protection, Collection Box), since all adjustments
have already been made.
6.5 Adjusting Sanding Tape Axis
Your MAKSIWA LDF sander is designed with the axis centralization mechanism. The tape sander
must run centered and properly drawn between the two axes. If any adjustments are necessary,
follow the following steps:
1. Turn on the machine.
2.
Insert a small Allen key into one of the holes on the adjustment wheel (A) in the figure below.
3. To pull the ribbon on the front of the machine (in front of the sandpaper) you must turn the
adjustment wheel front slowly down. To pull the ribbon on the rear of the machine you must turn
the wheel rear adjustment slowly upwards.
4. Check that the belt is properly centered and drawn between the two axes. If necessary, repeat
the above process.
5.
Turn the machine off.
