Mako SLINGSHOT JETBOARD, Operator'S Manual

Page: 11 / 74

07
MAKO SLINGSHOT OPERATORS GUIDE
MAKO OPERATOR’S GUIDE - GETTING STARTED
KNOW YOUR STATUS
Your jetboard features an LED status
indicator light that is located near the
battery housing, on the deck of the
board. This indicator light provides
run-time, error/warning and diagnostic
information about your jetboard.
The table below outlines the course of signalling for
each status of the LED indicator light. Should the LED
status indicator light on the deck of the board become
faulty, refer to the backup red-coloured status light
located directly on the Engine Control Unit, inside the
engine compartment.
The jetboard is powered
off and in its inactive
configuration.
Faulty, undercharged or flat
battery pack.
Faulty Engine Control Unit.
Unplugged ECU Connectors.
Faulty LED or connection.
DEFAULT / OFF
TROUBLESHOOTING STATUS DEFINITION INDICATOR LED STATUS
ENGINE S
HUT
-OFF PIN
S
TAR
T/S
TOP BUT
TON
Y/N
N
SOLID / ON
Y Y
The jetboard is powered on,
ECU is functioning correctly
and the starter is cranking the
engine for three seconds.
The LED may appear to flash,
this is due to engine rotation
during starting, this is normal.
SOLID / ON
Y N
The jetboard is powered on
and the engine is running
correctly. - - -
N Y
The engine shut-off pin is not
present or incorrectly located
in the hand control unit. Check for debris in rubber
housing on hand control.
Re-insert engine shut-off pin. SLOW FLASHING
FOR 3 SECONDS
Y Y
Engine failed to start correctly.
Starter protection active. Wait
ten seconds before attempting
another start. Check spark plug. Ensure
engine is primed with fuel.
Check jetdrive for obstruction.
Ensure drive shaft rotates
freely.
RAPID FLASHING
Y
Y/N
The battery pack has 20%
of its full charge capacity
remaining. Return to dry
land immediately. Charge battery pack.
Replace battery pack.
N Y
START/STOP button held for
longer than 5 seconds. Engine
drain procedure engaged.
Engine cranking until START/
STOP button released.
Ensure spark plug removed.
Process can also be used
to test ignition sensor is
functioning correctly. SLOW FLASHING
AT ENGINE RPM
RAPID FLASHING
FOR 10 SECONDS