㩷
18
STORAGE
– When the machine is in storage for a long time, drain fuel from the fuel tank
and carburetor, as follows: Drain all fuel from the fuel tank. Dispose of
properly and in accordance with all local laws.
– Remove the spark plug and a few drops of oil into the spark plug hole. Then,
pull the starter gently, so that oil covers the engine inside and tighten the
spark plug.
– Clear dirt or dust from the cutter blade or the nylon cutting head and outside
of engine, wipe them with a oil-immersed cloth and keep the machine in a
place as dry as possible.
Maintenance schedule
General
Engine assembly, screws and
nuts
Visual inspection for damage and tightness
Check for general condition and security
After each refuelling
Control lever
I-O-switch
Functional check
Functional check
Daily
Air filter
Cooling air duct
Cutting tool
Idling speed
To be cleaned
To be Cleaned
Check for damage and sharpness
Inspection (cutting tool must not move)
Weekly
Spark plug
Muffler
Inspection, replace if necessary
Check and if necessary clean the opening
Quarterly
Suction head
Fuel tank
To be replaced
To be cleaned
Shuting down procedure
Fuel tank
Carburetor
Empty fuel tank
Operate until engine runs out of fuel
Fault location
Fault System
Observation
Cause
Engine not starting or with
difficulty
Ignition system
Ignition spark O.K.
Fault in fuel supply or compression system, mechanical
defect
No ignition spark
STOP-switch operated, wiring fault or short circuit, spark
plug or connector defective, ignition module faulty
Fuel supply
Fuel tank filled
Incorrect choke position, carburetor defective, fuel supply
line bent or blocked, fuel dirty.
Compression
No compression when
pulled over
Cylinder bottom gasket defective, crankshaft seals
damaged, cylinder or piston rings defective or improper
sealing of spark plug
Mechanical fault
Starter not engaging
Broken starter spring, broken parts inside of the engine
Warm start problems
Tank filled ignition spark
existing
Carburetor contaminated, have it cleaned
Engine starts but dies
Fuel supply
Tank filled
Incorrect idling adjustment, carburetor contaminated
Fuel tank vent defective, fuel supply line interrupted,
cable or STOP-switch faulty
Insufficient performance
Several systems
may simultaneously
be affected
Engine idling poor
Air filter contaminated, carburetor contaminated, muffler
clogged, exhaust duct in the cylinder clogged
㩷
㩷
Drain fuel
Humidity
Summary of Contents for RBC2100
Page 2: ......
Page 57: ......
Page 58: ...Makita Corporation Anjo Aichi Japan www makita com 885158 939 ...