P 10/ 10
W
iring diagram
Route Field lead wires through
the opening of Motor housing while
tightening them in the housing.
Fig. D-2
Fig. D-3
Wiring from Motor housing
Wiring to Switch
Lead wire
holder
Spindle
Rib A
Rib B
Inner wall
Noise suppressor (if it is used.)
Opening
A
Lock-on button
B. Connect terminals of Power supply cord
to Switch while facing their wire connected
portion to Cord guard.
Put Noise suppressor on Field lead wire.
A. Connect terminals of Field lead wires to
Switch while facing their wire connected
portion to Motor housing.
Field lead wires
Noise suppressor
Lead wires of
Power supply cord
B
Wiring in Handle set
Fix this Field lead wire
in this Lead wire holder.
Inflect these Connectors
so that Lead wires do not
interferes with the other
connectors on the same line.
Fix Field lead wires in this
Lead wire holder.
Note
: Don’t slack these wires.
Route Lead wire (brown or black) of
Power supply cord between Rib B
and Inner wall of Handle set.
Route Field lead wire and one of
Lead wire of Noise suppressor
between Rib A and Inner wall
of Handle set.
Tighten Field lead wires
in Motor housing by pulling
out them to Handle section.