P 5 / 6
R
epair
[3] -3. Planing Depth Adjustment
Fig. 13
Planing depth has to be adjusted when replacing any of the following parts; Knob 50, Front base, Main frame complete
The adjusting mechanism of MT110 is designed so that one turn of Knob 50 lifts up/down Front base by 3mm. (Fig. 13)
3mm
Planing depth
adjusted to 0mm
With one turn of knob 50,
adjusted to 3mm, max planing depth
Knob 50
Pointer on
Main frame
1) Remove Scale label from Knob 50, then assemble Front base section. (Fig. 14)
2) Put the tool on a completely flat surface such as the table of stationary planers or the turn table of LS-series models.
(If these tools are not available, use a stainless steel scale instead.) (Fig. 15)
Fig. 14
Fig. 15
Fig. 16
Fig. 17
Front base
Rubber packing
Main frame
Flat washer
Knob 50
Planer jointer
MT110
Compression
spring 17
3) Turn Knob 50 so that the height of Front base is completely aligned with that of Rear base (bottom of Main frame) as
illustrated in Fig. 16.
4) Adhere new Scale label to Knob 50 so that the line of 0/3mm on Scale label is aligned with the apex of the pointer
on Main frame complete as illustrated in Fig. 17.
Front base
Rear Base
(bottom of Main frame)
Line of 0/3mm Mark
BASICS
WHEN AND HOW TO ADJUST
Scale label
Table of planer jointer
