W
iring diagram
P 7 / 7
Handle and Motor Housing
Brush
holder
Terminal
Lead unit
Lead wire holder
Lead wire
holder
Lead wire holder
Power supply circuit
Micro switch
See Fig.S.
Main switch
Censormatic chip
The hole for
flat head square
neck bolt M6x90
Brush
holder
Lead wire holder
Put censormatic chip
into place at front handle
if it is used.
Pass the lead wires of power
supply circuit through this hole
to the blade case section.
Lead wires (black and red) of
brush holders have to be expanded
near these lead holders to avoid
the lead wires' contacts with M6x90
flat head square neck bolt .
The lead wires should not be pinched. Bending the terminals of Micro switch are
acceptable when the lead wires of micro switch are apt to be pinched by walls of
Motor housing and Handle cover. See below for the detail.
This receptacle should be connected
to Terminal so as to face the lock
button for the Battery.
Battery's
lock button
Battery
These lead wires
are apt to be pinched.
These lead wires are not pinched.
Terminal
Wall of Handle cover
Inflected
terminals
Micro switch
Power supply
circuit
Wiring of Micro Switch
Wrong
Wrong
Wrong
