P 9 / 11
R
epair
[3] DISASSEMBLY/ASSEMBLY
[3] -4. Front base, Base (rear side)
[3] -5. Foot
ASSEMBLING, ADJUSTMENT
Fig. 14
Fig. 15
(1) Mount Foot to Base. And assemble the Base to Main frame complete. Refer to
Fig. 13
.
(2) Mounting Rubber packing and Compression spring 18 to Front base, assemble the Front base
to Main frame complete. Refer to
Fig. 12
.
(3) Adjust with Knob 44, until “0” on the Scale label correspond to the actual planing depth “0” as shown in
Fig. 14
.
Ruler
Front base
Knob 44
Base (rear side)
1. Apply a ruler on the surface of Base
and align Front base level by turning
Knob 44 to the same level of (rear) Base.
Now, the machine has been adjusted
to “Planning depth at 0”.
2. Stick Scale label on the Knob 44,
while aligning “0” to the Triangle
mark on the main fame.
Triangle mark
fresh Scale label
2a. If the removed Knob 44 is reused without sticking new Scale label, “0” may deviate from the
Triangle mark by 180 degrees.
Remove knob 44 again in this case, and approach to drive from the point deviating by 180 degrees
from the old approaching point. So, “0” can exactly align to the Triangle mark.
DISASSEMBLING
ASSEMBLING
Disassemble Base (rear side). So, Foot is removed together with Base as shown in
Fig. 13
.
Assemble Foot to Base as shown in
Fig. 15
.
Tail of Torsion
spring 7
long axis
short axis
Torsion spring 7
Torsion spring 7
1. Set Torsion spring 7 to long axis of Foot.
2. Put one of tail of Torsion spring 7
to Base as shown in the photograph
below.
Foot
