![background image](http://html.mh-extra.com/html/makita/lxjp02/lxjp02_instruction-manual_1722835005.webp)
5
FUNCTIONAL DESCRIPTION
CAUTION:
•
Always be sure that the tool is switched off and the
battery cartridge is removed before adjusting or
checking function on the tool.
Installing or removing battery cartridge
1
2
3
012517
•
Always switch off the tool before installing or
removing of the battery cartridge.
•
To remove the battery cartridge, slide it from the tool
while sliding the button on the front of the cartridge.
•
To install the battery cartridge, align the tongue on
the battery cartridge with the groove in the housing
and slip it into place. Always insert it all the way
until it locks in place with a little click. If you can see
the red indicator on the upper side of the button, it is
not locked completely. Install it fully until the red
indicator cannot be seen. If not, it may accidentally
fall out of the tool, causing injury to you or someone
around you.
•
Do not use force when installing the battery
cartridge. If the cartridge does not slide in easily, it
is not being inserted correctly.
Adjusting the depth of groove
1
2
3
4
012682
6 grooving depths can be preset according to the size of
biscuit to be used.
Refer to the table below for the correspondence between
the sizes marked on the stopper and the biscuit size.
Fine adjustments to the grooving depth can be made by
turning the adjusting screw after loosening the hex nut.
This may become necessary after the blade has been
resharpened a few times.
Size on stopper
0
10
20
S
D
MAX
Biscuit size
0
10
20
-
-
-
Depth of groove
8 mm
(0.3")
10 mm
(0.4")
12.3mm
(0.48")
14.7mm
(0.58")
13 mm
(0.51")
20 mm
(0.8")
*
* With the rubber spikes removed.
012683
Angle guide
The angle guide height can be moved up and down to
adjust the position of the blade in relation to the top of the
workpiece.
1
2
3
4
5
6
7
012497
To adjust the angle guide height, loosen the lock lever
down and rotate the knob until the pointer points to the
desired scale graduation marked on the angle guide.
1
2
3
4
012498
Then tighten the lock lever up to secure the angle guide.
The scale on the angle guide indicates the distance from
the top of the workpiece to the center of the blade
thickness.
The angle guide is removable from the fence according
to the need of your work. To remove the angle guide,
loosen the lock lever and turn the knob clockwise until it
comes out of the upper end of the fence.
Fence
NOTE:
•
Remove the angle guide according to the need of
your work when using the tool with the angle of the
fence adjusted to other than 0
゚
. When you need to
use the angle guide under the above condition, be
sure to adjust the depth of groove to get a proper
depth.
1. Knob
2. Down
3. Up
4. Center of blade
thickness
1. Lock lever
2. Angle guide
3. Knob
4. Scale
5. Pointer
6. Tighten
7. Loosen
1. Pointer
2. Stopper
3. Adjusting screw
4. Rubber spike
1. Button
2. Red indicator
3. Battery cartridge