(3)ASSEMBLY OF SAFETY COVER
1) Insert Spiral spring 26 into the oval hole in Safety cover , making spring's tip meet the hole.
2) Making Center washer meet four bosses in Safety cover , and attach it. (See Fig.1)
3) By putting the tip of Spiral spring 26 into Center cover hole, attach Center cover as shown in Fig. 2.
4) Attach Center plate, making it meet four bosses in Safety cover, and tighten it with Pan head screw M5.
Oval hole in Safety cover
Spiral spring 26
Flat washer 5
Pan head screw M5
Spiral spring 26
Center cover hole
Center washer
Center plate
Center cover
Safety cover
Fig. 1
Fig. 2
(4)ASSEMBLY OF SQUARE ROD COMPLETE AND RING 26
1) Passing Ring 26 through Slide pipe 25-235 as in the figure, attach Arm-holder complete to Turn base complete.
2) Slide Arm-holder complete until the groove on the top of Slide pipe 25-235 comes to the center of Turn base,
and then attach Square rod complete.
3) Attach Thumb nut 6x33 and H.socket bolt to meet the hole of Turn base and that of Ring26.
(5)ASSEMBLY/DISASSEMBLY OF TURN BASE AND BASE
1) When detaching/ attaching Turn base from/to Base, push Lock lever first.
2) Adjust the torque of Hex. lock nut M8 in the center of Turn base so that Turn base may turn smoothly without trembling.
Thumb nut 6x33
Hex. lock nut M8
Turn base
Base
Lock lever
Arm-holder complete
Ring 26
Turn base complete
Square rod complete
Rubber pin
Slide pipe 25-235
H.socket bolt
