7 ENGLISH
ENGLISH (Original instructions)
SPECIFICATIONS
Model
LS1440
Blade diameter
355 mm
Hole diameter
For other than European countries
25 mm or 25.4 mm (Country specific)
For European countries
25 mm
Max. kerf thickness of the saw blade
3.4 mm
Max. Miter angle
Left 45° , Right 45°
No load speed
3,900 min
-1
Dimensions (L x W x H)
596 mm x 550 mm x 630 mm
Net weight
33.1 kg
Safety class
/II
•
Due to our continuing program of research and development, the specifications herein are subject to change
without notice.
•
Specifications may differ from country to country.
•
Weight according to EPTA-Procedure 01/2014
Max. Cutting capacities (H x W)
Miter angle
0°
45° (left and right)
122 mm x 152 mm
122 mm x 115 mm
Symbols
The followings show the symbols used for the equipment.
Be sure that you understand their meaning before use.
Read instruction manual.
DOUBLE INSULATION
To avoid injury from flying debris, keep hold
-
ing the saw head down, after making cuts,
until the blade has come to a complete stop.
Do not place hand or fingers close to the
blade.
For your safety, remove the chips, small
pieces, etc. from the table top before
operation.
Only for EU countries
Do not dispose of electric equipment
together with household waste material! In
observance of the European Directive, on
Waste Electric and Electronic Equipment
and its implementation in accordance with
national law, electric equipment that have
reached the end of their life must be col-
lected separately and returned to an envi-
ronmentally compatible recycling facility.
Intended use
The tool is intended for accurate straight and miter
cutting in wood. With appropriate saw blades, aluminum
can also be sawed.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated and can, therefore, also be used
from sockets without earth wire.
For public low-voltage distribution
systems of between 220 V and 250 V
Switching operations of electric apparatus cause voltage
fluctuations. The operation of this device under unfavor
-
able mains conditions can have adverse effects to the
operation of other equipment. With a mains impedance
equal or less than 0.39 Ohms it can be presumed that
there will be no negative effects. The mains socket used
for this device must be protected with a fuse or protec-
tive circuit breaker having slow tripping characteristics.
Noise
The typical A-weighted noise level determined accord-
ing to EN62841-3-9:
Sound pressure level (L
pA
) : 94 dB(A)
Sound power level (L
WA
) : 105 dB (A)
Uncertainty (K) : 3 dB(A)
NOTE:
The declared noise emission value(s) has been
measured in accordance with a standard test method
and may be used for comparing one tool with another.
NOTE:
The declared noise emission value(s) may
also be used in a preliminary assessment of exposure.