Makita LS1018, Instruction Manual

Page: 13 / 132

13
Electronic function
Soft start feature
•
This function allows the smooth start-up of the tool
by limiting the start-up torque.
Laser beam action
For model LS1018L only
NOTE:
•
Before the first use, install the dry cells provided
separately from the tool in the cell box. Refer to the
section titled "Replacing the dry cells for laser unit"
for the installment.
CAUTION:
•
When not in use, be sure to turn off the laser
Fig.18
CAUTION:
•
Never look into the laser beam. Direct laser beam
may injure your eyes.
•
LASER RADIATION, DO NOT STARE INTO THE
BEAM, CLASS 2 LASER PRODUCT.
•
Before shifting the laser line or performing
maintenance adjustment, be sure to unplug the
tool.
To turn on the laser beam, press the upper position (I) of
the switch. To turn off the laser beam, press the lower
position (0) of the switch.
Laser line can be shifted to either the left or right side of
the saw blade by loosening the screw holding the laser
unit box and shifting it in the desired direction. After
shifting, be sure to tighten the screw.
1
010473
Laser line is factory adjusted so that it is positioned within
1 mm from the side surface of the blade (cutting
position).
NOTE:
•
When laser line appears dim and hard to see
because of direct sunlight, relocate the work area to
a place where there is less direct sunlight.
Replacing the dry cells for laser unit
Fig.19
Fig.20
Remove the lid for the dry cells for laser unit by sliding
while pressing it. Take out the old dry cells and put the
new ones as shown in the figure. After replacing, return
the lid to cover it.
Cleaning of the lens for the laser light
If the lens for the laser light becomes dirty, or sawdust
adheres to it in such a way that the laser line is no longer
easily visible, unplug the saw and remove and clean the
lens for the laser light carefully with a damp, soft cloth.
Do not use solvents or any petroleum-based cleaners on
the lens.
NOTE:
•
When laser line is dim and almost or entirely
invisible because of the direct sunlight in the indoor
or outdoor window-by work, relocate the work area
to a place not exposed to the direct sunlight.
ASSEMBLY
WARNING:
•
Always be sure that the tool is switched off and
unplugged before working on the tool.
Failure to
switch off and unplug the tool may result in serious
personal injury.
Storage of socket wrench with hex wrench on
its other end
Fig.21
The socket wrench is stored as shown in the figure.
When the socket wrench is needed it can be pulled out of
the wrench holder. After using the socket wrench it can
be stored by returning it to the wrench holder.
Installing or removing saw blade
WARNING:
•
Always be sure that the tool is switched off and
unplugged before installing or removing the
blade.
Accidental start up of the tool may result in
serious personal injury.
•
Use only the Makita socket wrench provided to
install or remove the blade.
Failure to use the
wrench may result in overtightening or insufficient
tightening of the hex bolt and serious personal
injury.
Fig.22
Lock the handle in the raised position by pushing in the
stopper pin.
Fig.23
To remove the blade, use the socket wrench to loosen
the hex bolt holding the center cover by turning it
counterclockwise. Raise the blade guard and center
cover.
1. Screw holding the laser unit box