12
Max. Cutting capacities (H x W) with 216 mm in diameter
Symbols
END326-1
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
............. Read instruction manual.
............. DOUBLE INSULATION
......... To avoid injury from flying debris, keep
holding the saw head down, after making
cuts, until the blade has come to a
complete stop.
When performing slide cut, first pull
carriage fully and press down handle,
then push carriage toward the guide
fence.
............. Do not place hand or fingers close to the
blade.
.......... Adjust sliding fences clear of blade and
blade guard properly.
...... LASER RADIATION: Do not stare into
beam. Direct laser beam may injure your
eyes.
............... Only for EU countries
Due to the presence of hazardous
components in the equipment, used
electrical and electronic equipment may
have a negative impact on the
environment and human health.
Do not dispose of electrical and
electronic appliances with household
waste!
In accordance with the European
Directive on waste electrical and
electronic equipment and its adaptation
to national law, used electrical and
electronic equipment should be collected
separately and delivered to a separate
collection point for municipal waste,
operating in accordance with the
environmental protection regulations.
This is indicated by the symbol of the
crossed-out wheeled bin placed on the
equipment.
Intended use
ENE006-1
The tool is intended for accurate straight and miter cutting
in wood. With appropriate saw blades, aluminum can also
be sawed.
Power supply
ENF002-2
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated and can, therefore, also be used from
sockets without earth wire.
SAFETY WARNINGS
General power tool safety
warnings
GEA010-2
WARNING: Read all safety warnings, instructions,
illustrations and specifications provided with this
power tool.
Failure to follow all instructions listed below
may result in electric shock, fire and/or serious injury.
Save all warnings and
instructions for future reference.
The term “power tool” in the warnings refers to your
mains-operated (corded) power tool or battery-operated
(cordless) power tool.
Safety instructions for mitre saws
ENB130-2
1.
Mitre saws are intended to cut wood or wood-like
products, they cannot be used with abrasive cut-
off wheels for cutting ferrous material such as
bars, rods, studs, etc.
Abrasive dust causes moving
parts such as the lower guard to jam. Sparks from
abrasive cutting will burn the lower guard, the kerf
insert and other plastic parts.
2.
Use clamps to support the workpiece whenever
possible. If supporting the workpiece by hand, you
must always keep your hand at least 100 mm from
either side of the saw blade. Do not use this saw to
cut pieces that are too small to be securely
clamped or held by hand.
If your hand is placed too
close to the saw blade, there is an increased risk of
injury from blade contact.
3.
The workpiece must be stationary and clamped or
held against both the fence and the table. Do not
feed the workpiece into the blade or cut
“freehand” in any way.
Unrestrained or moving
Miter angle
Bevel angle
45° (left)
5° (right)
0°
0°
50 mm x 305 mm
60 mm x 305 mm
65 mm x 305 mm
45°
50 mm x 215 mm
-
65 mm x 215 mm
60° (right)
-
-
65 mm x 150 mm
