29
For both adjustments, do as follows.
1.
Make sure that the tool is unplugged.
2.
Draw the cutting line on the workpiece and place it on the turn table. At
this time, do not secure the workpiece with a vise or similar securing
device.
3.
Lower the blade by lowering the handle and just check to see where the
cutting line and the position of the saw blade is. (Decide which position to
cut on the line of cut.)
4.
After decision the position to be cut, return the handle to the original
position. Secure the workpiece with the vertical vise without shifting the
workpiece from the pre-checked position.
5.
Plug the tool and turn on the laser switch.
6.
Adjust the position of laser line as follows.
The position of laser line can be changed as the movable range of the adjust-
ing screw for the laser is changed by turning two screws with a hex wrench.
(The movable range of laser line is factory adjusted within 1 mm from the side
surface of blade.)
To shift the laser line movable range further away from the side surface of
blade, turn the two screws counterclockwise after loosening the adjusting
screw. Turn these two screws clockwise to shift it closer to the side surface of
the blade after loosening the adjusting screw.
Refer to the section titled “Laser line action” and adjust the adjusting screw so
that the cutting line on your workpiece is aligned with the laser line.
NOTE:
•
Check the position of laser line regularly for accuracy.
•
Have the tool repaired by Makita authorized service center for any failure
on the laser unit.
Replacing fluorescent tube
For Models LS0814F and LS0814FL only
CAUTION:
•
Always be sure that the tool is switched off and unplugged before
replacing the fluorescent tube.
•
Do not apply force, impact or scratch to a fluorescent tube, which can
cause a glass of the fluorescent tube to be broken resulting in a injury to
you or your bystanders.
•
Leave the fluorescent tube for a while immediately after a use of it and
then replace it. If not. You may burn yourself.
Remove screws, which secure Lamp Box for the light.
1. Pull out
2. Push
3. Lamp box
4. Screws
5. Fluorescent tube
1
2
3
4
1
5
002028
