P 3 / 12
R
epair
[3] DISASSEMBLY/ASSEMBLY
[3] -1. Disassembling/ Assembling Blade Clamp Section
1) Remove shoe. If the blade clamp section is positioned inside
gear housing, pull it out of gear housing. (Fig. 2)
2) After removing protector, remove retaining ring S-18 with
Retaining Ring S and R Pliers (No.1R291).
Then remove the following parts:
Driving sleeve, Shoulder pin 5, Compression spring 6,
Pin 3 (of 6mm length), Guide sleeve, Driving sleeve guide
Now sleeve appears. (Fig. 3 )
3) Because sleeve is locked, release it
by pulling in the direction of the blade
installation side. (Fig. 4)
DISASSEMBLING
Fig. 2
Shoe
Blade clamp section
Fig. 3
Driving sleeve
Shoulder pin 5
Compression spring 6
Driving sleeve guide
Pin 3
(of 6mm length)
Guide sleeve
Sleeve
Protector
Retaining ring S-18
4) While putting your finger on the top of slider to close the slit of slider, remove pin 3 (of 19.8mm length) by pushing
with a thin bar. (Fig. 5)
Note: Be sure to put your finger on the top of slider or push plate will pop out from the slit of slider.
5) Remove sleeve and torsion spring 17 from slider, then take push plate and compression spring 2 out of the slit of
slider. (Fig. 6)
Push plate
Compression
spring 2
Sleeve
Slider
Torsion
spring 17
Fig. 5
Fig. 6
Slider
Sleeve
thin bar
Pin 3
(of 19.8mm length)
Fig. 4
Sleeve
(Pull in the direction of
the blade installation side.)
Pin 3 is positioned
at the lower end of
the groove on sleeve
when sleeve is released.
groove
[Sleeve Locked]
[Sleeve Released]
Pin 3 (of 19.8mm length)
