Makita GA9070, Instruction Manual

Page: 13 / 20

13 ENGLISH
Installing or removing abrasive cut-
off / diamond wheel
Optional accessory
WARNING:
When using an abrasive cut-off
/ diamond wheel, be sure to use only the special
wheel guard designed for use with cut-off wheels.
(In some European countries, when using a diamond
wheel, the ordinary guard can be used. Follow the
regulations in your country.)
WARNING:
NEVER use cut-off wheel for side
grinding.
Mount the inner flange onto the spindle.
Fit the wheel / disc on the inner flange and screw the
lock nut onto the spindle.
3
4
2
1
►
1. Lock nut 2.
Abrasive cut-off wheel / diamond
wheel 3.
Inner flange
4. Wheel guard for abrasive
cut-off wheel / diamond wheel
For Australia and New Zealand
ø45
ø78
ø78
1
2
3
4
5
►
1. Lock nut 2.
Outer flange 78
3.
Abrasive cut-off
wheel / diamond wheel 4.
Inner flange 78
5. Wheel
guard for abrasive cut-off wheel / diamond wheel
Installing wire cup brush
Optional accessory
CAUTION:
Do not use brush that is damaged,
or which is out of balance. Use of damaged brush
could increase potential for injury from contact with
broken brush wires.
1
►
1. Wire cup brush
Remove any accessories on spindle. Thread wire cup
brush onto spindle and tighten with the wrench.
Installing wire wheel brush
Optional accessory
CAUTION:
Do not use wire wheel brush that
is damaged, or which is out of balance. Use of
damaged wire wheel brush could increase potential
for injury from contact with broken wires.
CAUTION:
ALWAYS use guard with wire
wheel brushes, assuring diameter of wheel fits
inside guard. Wheel can shatter during use and
guard helps to reduce chances of personal injury.
1
►
1. Wire wheel brush
Remove any accessories on spindle. Thread wire wheel
brush onto spindle and tighten with the wrench.