P
9
/ 1
0
R
epair
(8) Assemble Refueling winding to Refueling handle group as drawn in
Fig. 12
.
(9) Assemble Refueling winding to Throttle lever of Carburetor as drawn in
Fig. 13
.
Fig. 12
Fig. 13
Curve
Groove
Stopper
Sheath
Refueling handle group
1. Align the hole for Stopper of Refueling winding
to the curve of
Refueling handle group
.
2. Insert Stopper of Refueling winding
into the hole along the curve.
3. Put the inner cable of Refueling winding
into the groove of
Refueling handle group
.
4. Connect the sheath of Refueling winding
to the original position of Refueling handle
group.
5. Guide the other end of Refueling
winding to Carburetor side by passing
it under Pump frame.
1. Connect the other end of Refueling winding to Carburetor. Then align the lever of
Refueling handle group
to “L” position. And then make sure that Adjusting screw of
Carburetor is contacted to
Throttle lever of Carburetor
.
If the screw is not connected to the lever, regulate
Adjust screw
until Adjusting screw
of Carburetor contacts
Throttle lever of Carburetor
.
Pump frame
Adjust screw
2. Assemble Air cleaner cover with M5x14 Pan head screw.
Air cleaner cover
ASSEMBLING
[3] DISASSEMBLY/ASSEMBLY
[3] -1. Pump Section (cont.)
Adjusting screw of Carburetor comes
in contact with Throttle lever of
Carburetor at “L” position of
Refueling handle group.
