![background image](http://html1.mh-extra.com/html/makita/ea3500s/ea3500s_operators-and-safety-manual_3962795027.webp)
27
Refuelling
FOLLOW THE SAFETY PRECAUTIONS!
Be careful and cautious when handling fuels.
The engine must be switched off!
Thoroughly clean the area around the caps, to prevent dirt
from getting into the fuel or oil tank.
Unscrew the tank cap (use the universal wrench if necessary,
see illustration) and fill tank with fuel mixture or saw chain
oil up to the bottom edge of the filling neck. Be careful not to
spill fuel or chain oil!
Screw on the tank cap
by hand all the way.
Clean the tank cap and the area around the tank after
refuelling.
Lubricating the chain
During operation there must always be sufficient chain
oil in the chain-oil tank to provide good chain lubrication.
At medium oil feed rate, the oil tank holds enough for one
fuel tank’s worth of operation. During this procedure check
whether there is enough the chain oil in the tank and refill if
necessary.
Do this only with the engine turned off!
Screw
on the tank
cap
by hand all the way.
waste oil
NEVER USE WASTE OIL
Waste oil is very dangerous for the environment.
Waste oil contains high amounts of carcinogenic substances.
Residues in waste oil result in a high degree of wear and tear
at the oil pump and the sawing device.
In case of damage caused by using waste oil or inappropriate
chain oil the product guarantee will be null and void.
Your salesman will inform you about the use of chain oil.
AVOID SKIN AND EYE CONTACT
Mineral oil products degrease your skin. If your skin comes
in contact with these substances repeatedly and for an
extended period of time, it will desiccate. Various skin
diseases may result. In addition, allergic reactions are known
to occur.
Eyes can be irritated by contact with oil. If oil comes into your
eyes, immediately wash them with clear water.
If your eyes are still irritated, see a doctor immediately!
Important note on bio-degradable chain oils
If you are not planning to use the saw again for an
extended period of time, empty the oil tank and put in a
small amount of regular engine oil (SAE 30), and then
run the saw for a time. This is necessary to flush out all
remaining bio-degradable oil from the oil tank, oil-feed
system, chain and guide bar, as many such oils tend
to leave sticky residues over time, which can cause
damage to the oil pump or other parts.
The next time you use the saw, fill the tank with BIOTOP
chain oil again. In case of damage caused by using waste
oil or inappropriate chain oil the product guarantee will be
null and void.
Your salesman will inform you about the use of chain oil.
chain oil
fuel/oil mixture