Makita DUB362PT4X, Instruction Manual

Page: 7 / 60

7
Indicating the remaining battery capacity
(Fig. 2)
(Only for battery cartridges with “B” at the end of the
model number.)
Press the check button on the battery cartridge to
indicate the remaining battery capacity. The indicator
lamps light up for few seconds.
Indicator lamps
Remaining
capacity
Lighted Off Blinking
75% to 100%
50% to 75%
25% to 50%
0% to 25%
Charge the
battery.
The battery
may have
malfunctioned.
015658
NOTE:
• Depending on the conditions of use and the ambient
temperature, the indication may differ slightly from the
actual capacity.
Remaining battery capacity indication (Fig. 3)
(Country specific)
Press the check button to make the battery indicators
show the remaining battery capacities. The battery
indicators correspond to each battery.
Remaining battery capacity indication
Battery indicator status
Remaining battery
capacity
: On : Off : Blinking
50% – 100%
20% – 50%
0% – 20%
Charge the battery
015527
Switch action (Fig. 4 & 5)
CAUTION:
• Before inserting the battery cartridge into the tool,
always check to see that the switch trigger actuates
properly and returns to the “OFF” position when
released.
To start the tool, simply pull the switch trigger. Tool speed
is increased by increasing pressure on the switch trigger.
Release the switch trigger to stop.
For continuous operation, pull the switch trigger, push
in the lock button and then release the switch trigger.
To stop the tool from the locked position, pull the switch
trigger fully, then release it.
Speed change (Fig. 6)
The maximum air volume can be adjusted just by turning
the adjusting dial. This can be done even while the tool
is running. The dial is marked 1 (lowest) to 6 (highest).
NOTICE:
• The speed adjusting dial can be turned only as far as 6
and back to 1. Do not force it past 6 or 1, or the speed
adjusting function may no longer work.
When working in a high temperature circumstance, the
tool may be stopped because of the overheat protection
system. In that case let the tool cool down. Avoid setting
to speed 6 (highest) in high temperature circumstances.
ASSEMBLY
CAUTION:
• Always be sure that the tool is switched off and the
battery cartridge is removed before carrying out any
work on the tool.
Installing the long nozzle (Fig. 7 & 8)
To install the long nozzle:
1. Align the small projection of the housing with the
groove of the long nozzle.
2. Slide in the long nozzle, and turn it clockwise until the
triangle markings on the long nozzle and the housing
meet each other.
The length of the nozzle can be adjusted by changing the
locking position.
Installing the extension nozzle / flat nozzle
(optional accessory)
The extension nozzle / flat nozzle can be installed on the
tip of the long nozzle in the same way as above.
Installing the shoulder strap (optional accessory)
(Fig. 9)
Hook the shoulder strap onto the hanger of the tool.
Before use, adjust the length of strap so that it is easy
to work with it.