14 ENGLISH
2.
Lift up the guide bar tip slightly and adjust the
chain tension. Turn the chain adjusting screw counter
-
clockwise to tighten, turn it clockwise to loosen.
Tighten the saw chain until the lower side of the saw
chain fits in the guide bar rail as illustrated.
1
2
3
Fig.20
►
1.
Guide bar
2.
Saw chain
3.
Chain adjusting screw
3.
Keep holding the guide bar lightly and attach the
sprocket cover.
Make sure that the saw chain does not loose at the
lower side.
4.
Tighten the retaining nut to secure the sprocket
cover.
1
Fig.21
►
1.
Retaining nut
Installing or removing the angled
attachment
Optional accessory
CAUTION:
Before installing or removing the
angled attachment, be sure to attach the guide
bar cover to the tool.
You can change the angle of the tool head by attaching
the angled attachment to the tool.
1.
Loosen the lock ring by turning the lock ring coun
-
terclockwise, then extend the pipe approximately 10
cm (3-15/16″) or more, and then tighten the lock ring by
turning the lock ring clockwise.
1
2
3
Fig.22
►
1.
10 cm (3-15/16″) or more
2.
Lock ring
3.
Pipe
2.
Loosen 2 bolts with the hex wrench, and then
remove the pipe from the head of the tool.
1
Fig.23
►
1.
Bolt
