8 ENGLISH
When drilling into concrete or tiles, point the arrow at
the
mark for hammer drill mode.
When drilling into wood or metal, point the arrow at
the
mark for drill mode.
When driving small wood screws or machine screws,
point the arrow at the
mark for screwdriver mode.
The fastening torque can be adjusted on the LED
display.
CAUTION:
•
Always set the arrow correctly to either mode
mark. If you operate the tool with the action
mode changing ring positioned halfway between
the mode marks, the tool may be damaged.
•
When turning the action mode changing ring,
make sure that the tool stops. If the ring does
not easily move, pull the switch trigger slightly to
rotate the spindle and then move the ring.
•
In the hammer drill mode or drill mode, the blow-
ing force or torque is not adjustable. In those
modes, the number on the LED display will be off.
Changing the impact force (impact driver mode)
1
2
3
4
5
1.
Changed in three steps
2.
Hard
3.
Medium
4.
Soft
5.
Control button
Impact force grade
displayed on panel
Maximum blows
Application
Work
Hard
Medium
Soft
Tightening when force
and speed are desired.
Tightening when a good
finishing is needed.
Tightening when excessive
tightening need to be avoided
because of potentially clogged
female screw and broken or
damaged screw head.
Tightening in underwork
material/ Tightening long
screws/ Tightening bolts.
Tightening in the finishing
board, plaster board.
Tightening sash screw/
Tightening small screws
such as M6.
3,200
(min )
-1
DTP131
DTP141
3,200
(min )
-1
2,400
(min )
-1
2,400
(min )
-1
1,200
(min )
-1
1,200
(min )
-1
The impact force can be changed in three steps: hard, medium and soft.
This allows a tightening suitable to the work.
Every time the button
is pressed, the impact force grade changes in three steps.
For approximately one minute after releasing the switch trigger, the impact force can be changed.
