Makita DST221Z, Instruction Manual

Page: 7 / 12

7
1
2
009153
To secure the sub magazine in place, hook the locking
lever on the rear of the sub-magazine.
CAUTION:
•
With the magazine loaded, if the tool is held
downward and the sub-magazine is opened, the
staples can fall out and present a danger to anyone
or anything below. Keep this in mind especially
when working in high locations.
Unloading staples
CAUTION:
•
When removing staples, make sure that your
fingers are not placed on the trigger or the lever and
the battery cartridge is removed from the stapler.
Misfiring may cause personal injuries and property
damage.
Remove the battery cartridge.
Press the locking lever and slide the magazine back.
1
2
009152
Take out staples from the magazine slit.
1
2
009162
Hook
CAUTION:
•
Always make sure that your fingers are not placed
on the trigger or the lever and the battery cartridge
is removed before using the hook.
1
2
3
009155
CAUTION:
•
Do not hang the hook from the waist belt. Dropping
the stapler, which is caused by the hook
accidentally coming out of place, may cause
misfiring and personal injuries.
The hook is convenient for temporarily hanging the tool.
This can be installed on either side of the tool.
To install the hook, insert it into a groove in the tool
housing on either side and then secure it with a screw. To
remove, loosen the screw and then take it out.
009154
OPERATION
Depth adjustment
1
009163
If the staples are driven too deep or too shallow, adjust
the driving depth by turning the nut on the bottom of the
tool. For deeper driving of staples, turn the nut clockwise.
For shallower driving, turn the nut counterclockwise.
Please note the nut must be turned in increments of 90°
1. Nut
1. Groove
2. Hook
3. Screw
1. Sub magazine
2. Locking lever
1. Sub magazine
2. Locking lever
1. Staples
2. Main magazine