3
ENGLISH (Original instructions)
Explanation of general view
1-1. Lock button
1-2. Speed control screw
1-3. Switch trigger
1-4. Higher
1-5. Lower
2-1. Reversing switch lever
3-1. Arrow
3-2. Speed change knob
4-1. Grip base
4-2. Side grip (auxiliary handle)
4-3. Teeth
4-4. Protrusions
5-1. Chuck key
6-1. Sleeve
6-2. Ring
7-1. Depth gauge
8-1. Vent holes
SPECIFICATIONS
Model DP4010/DP4011
Speed High
Low
Steel 8
mm 13
mm
Capacities
Wood
25 mm
40 mm
No load speed (min
-1
)
0 - 2,900
0 - 1,200
Overall length
347 mm
Net weight
2.3 kg
Safety class
/II
• Due to our continuing program of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
ENE032-1
Intended use
The tool is intended for drilling in wood, metal and
plastic.
ENF002-1
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated in accordance with European
Standard and can, therefore, also be used from sockets
without earth wire.
ENG104-1
For European countries only
Noise
The typical A-weighted noise level determined according
to EN60745:
Sound pressure level (L
pA
) : 80 dB (A)
Uncertainty (K) : 3 dB (A)
The noise level under working may exceed 80 dB (A).
Wear ear protection
ENG202-3
Vibration
The vibration total value (tri-axial vector sum)
determined according to EN60745:
Work mode: drilling into metal
Vibration emission (a
h,D
) : 2.5 m/s
2
or less
Uncertainty (K) : 1.5 m/s
2
ENG901-1
•
The declared vibration emission value has been
measured in accordance with the standard test
method and may be used for comparing one tool
with another.
•
The declared vibration emission value may also be
used in a preliminary assessment of exposure.
WARNING:
•
The vibration emission during actual use of the
power tool can differ from the declared emission
value depending on the ways in which the tool is
used.
•
Be sure to identify safety measures to protect the
operator that are based on an estimation of
exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
the times when the tool is switched off and when it
is running idle in addition to the trigger time).
ENH101-17
For European countries only
EC Declaration of Conformity
Makita declares that the following Machine(s):
Designation of Machine:
2-speed drill
Model No./ Type: DP4010,DP4011
Conforms to the following European Directives:
2006/42/EC
They are manufactured in accordance with the following
standard or standardized documents:
EN60745
The technical file in accordance with 2006/42/EC is
available from:
Makita, Jan-Baptist Vinkstraat 2, 3070, Belgium
Summary of Contents for DP4011
Page 33: ...33 1 2 3 I II I II 4 DP4010 5...
Page 34: ...34 DP4010 6 7 8 Makita Makita Makita...
Page 35: ...35 Makita 13...
