29 ENGLISH
1
2
►
1.
Left 45° adjusting bolt
2.
Right 45° adjusting bolt
Adjusting the laser line position
For DLS112 only
WARNING:
The batteries must be installed
while adjusting the laser line. Take extra care not to
switch on the tool during adjustment.
Accidental start
up of the tool may result in serious personal injury.
CAUTION:
Never look directly into the laser
beam.
Direct eye exposure to the beam could cause
serious damage to your eyes.
NOTICE:
Check the position of laser line regu-
larly for accuracy.
NOTICE:
Beware that impacts to the tool.
It may
cause the laser line to be misaligned or may cause
damage to the laser, shortening its life.
NOTICE:
Have the tool repaired by a Makita
authorized service center for any failure on the
laser unit.
The movable range of laser line is decided by the range
adjustment screws on both sides. Perform following
procedures to alter the laser line position.
1.
Remove the batteries.
2.
Draw a cutting line on the workpiece and place it
on the turn base. At this time, do not secure the work
-
piece with a vise or similar securing device.
3.
Lower the handle and align the cutting line with
the saw blade.
4.
Return the handle to the original position and
secure the workpiece with the vertical vise so that the
workpiece does not move from the position you have
determined.
5.
Install the batteries and turn on the laser switch.
6.
Loosen the adjusting screw. To move the laser line
away from the blade, turn the range adjustment screws
counterclockwise. To move the laser line close to the
blade, turn the range adjustment screw clockwise.
Adjusting the laser line on the left side of the blade
4
5
1
2
3
►
1.
Adjusting screw
2.
Range adjustment screw
3.
Hex wrench
4.
Laser line
5.
Saw blade
Adjusting the laser line on the right side of the
blade
4
5
1
2
3
►
1.
Adjusting screw
2.
Range adjustment screw
3.
Hex wrench
4.
Laser line
5.
Saw blade
Summary of Contents for DLS112
Page 31: ...31 ...
