27
Cleaning the inside of the sprocket guard
CAUTION: Before doing any work on the guide bar or chain,
always switch off the engine and pull the plug cap off the
spark plug
(see „Replacing the spark plug“)
. Always wear
protective gloves!
CAUTION: Start the chain saw only after having assembled
it completely and inspected.
Remove the sprocket guard (
1
) (see PUTTING INTO OPERA-
TION for the correct model) and clean out the interior with a
brush.
Remove the chain (
2
) and guide bar (
3
).
NOTE
:
Make sure there are no residues or foreign matter remaining in
the oil guide groove (
4
) or on the chain tensioner (
5
).
To install the guide bar, saw chain, and sprocket guard, see
PUTTING INTO OPERATION for the correct model.
NOTE:
The chain brake is a very important safety device and like
any other component subject to normal wear and tear.
Regular inspection and maintenance are important for
your own safety and must be done by a MAKITA service
centre
.
SERVICE
Cleaning the guide bar
CAUTION: Protective gloves must be worn.
Regularly inspect the bearing surfaces of the guide bar (
7
) for
damage, and clean them with a suitable tool.
Keep the two oiling holes (
6
) and the entire guide bar clean and
free of foreign matter!
4
5
1
3
2
6
7
Summary of Contents for DCS3501
Page 39: ...39 ...
