Makita BUR360RD, Technical Information

Page: 3 / 13

[3] DISASSEMBLY/ASSEMBLY
[3] -1. Bent pipe complete
DISASSEMBLING
Disassemble Bent pipe complete as drawn in
Fig. 2
.
Fig. 2
1. While inserting 1R308 into the hole of
Cutter holder to stop Cutter shaft revolving,
turn Cutter assembly counterclockwise by
hand. Cutter assembly is removed from
Cutter shaft.
2. Loosen two M6x30 Hex socket
head bolts and remove Protector
cover and Protector.
Note: The M6x30 Hex socket
head bolts have Spring
washer 6 on each thread
to prevent losing.
It is not necessary to
separate them from
Protector .
Remove M5x10 Hex socket
head bolt and Protector clamp
from Head case complete, and
then Remove Head case complete
from Bent pipe complete by
loosening M5x25 Hex socket
head bolt.
M6x30 Hex socket
head bolt (2 pcs.)
M5x10 Hex
socket head bolt
Protector
clamp
Protector
Protector
cover
Cutter
assembly
male thread of Cutter shaft
(connected with Cutter
assembly at its inside)
1R308
M5x25 Hex
socket head bolt
Head case
3. Remove two M5x25 Hex socket head bolts and
separate Loop handle set* from Bent pipe complete.
4. Unscrew the following screws and bolts (11 pcs. in total),
and separate Grip R from Grip L.
*M5x25 Hex socket head bolt (2 pcs.)
*mark: The components of Loop handle set
*Clamp
cover B
*Clamp 33
M5x20 Pan
head screw
Grip R
M5x20 Hex
socket head bolt
M5x18 Hex
socket head bolt
4x18 Tapping
screws (8 pcs.)
Grip L
5. Pull off Bent shaft pipe complete from Pipe bracket by hand.
6. Pull off Pipe rubber and Spacer from
Bent pipe complete.
Pipe bracket
Bent pipe
complete
Spacer
Note : Some specifications
have no Spacer.
Pipe rubber
Bent pipe
complete
R
epair
P 3 / 1 3
hole of Cutter
holder for 1R308
Bent pipe
complete
Bent pipe
complete
*Clamp 24
*Loop handle