P
9
/ 1
3
R
epair
[3] DISASSEMBLY/ASSEMBLY
[3] -4. Rotor, Stator (cont.)
Fig. 13
Fig. 14
ASSEMBLING
Assemble Rotor and Stator in the reverse order of disassembly. Refer to
Figs. 12, 11, and 10
.
Note 1
: Rotor dragged by strong magnet force may bump on Circuit plate of Stator and give damage on that plate.
Therefore, assemble Rotor as drawn in
Fig. 13
.
Note
2
: The mating face of Motor housing L tends to deviate from that of Motor housing R when assembling.
Therefore, assemble Motor housing L and Motor housing R as drawn in
Fig. 14
after setting Rotor and
Stator to Motor housing L.
Circuit plate
Worktable
1. Hold Rotor perpendicularly.
3. When Rotor’s ball bearing reaches
the surface of Worktable through
the shaft hole, move Stator slowly
toward Rotor fan.
2. Pass Rotor held in perpendicular
slowly through Stator, aiming
precisely at the shaft hole of
Circuit plate.
1. After mounting Rotor and
Stator to Motor housing L,
set Motor housing R to
Motor housing L.
2. Closely applying the drive end
(Gear side) to 1R350, stand
Motor housing set on 1R350.
3. The mating face of Motor housing R is
automatically aligned to that of Motor
housing L on 1R350.
And tighten three 4x18 Tapping screws.
1R350
Motor
housing set
4x18 Tapping screw
(3 pcs.)
Motor
housing L
Motor
housing R
