1. Remove Carbon brushes.
2. After separating Stop ring E-8, Lever 40, M6 Hex
nut and Flat washer from M6x90 Flat head screw,
loosen three M5x40 pan head screws. (Fig.15)
5. Pull Armature out of Motor housing.
6. Remove Ball bearings of the Armature.
Note: 1) When passing Armature through York unit, Armature is attracted to the magnet of Yoke unit.
Therefore, pay attention not to scratch Armature coils. Do not pinch your fingers between Fan of Armature and
Yoke unit.
2) When fixing Motor housing to Blade case complete, be sure to mount Motor housing transversely to Blade case
complete to prevent Baffle plate from being dropped out of Motor housing. (Fig. 15).
[7] Replacing Armature
Fig. 15
M5x40 Pan head screw
Motor housing
Baffle plate
Armature
Blade case
complete
Flat washer 6
Flat head square
neck bolt M6x90
M6 Hex nut
Lever 40
Stop ring
E-8
DISASSEMBLING
ASSEMBLING
[8] Adjusting for accuracy of 90 and 45 cut
For 90
For 45
Fig.16
As illustrated in Fig.16, use Triangular rule and hex wrench 2.5 to set the desired angle.
Adjust the fastening torque of M5 thrust head screw in order to prevent backlash when doing cutting depth adjustment.
See Fig.17.
Adjust the locked position of Lever 40 within 30 degrees from horizontal line as illustrated in Fig.18.
Adjust the locked position of Lever 30 within 20 degrees to right and left from vertical line as illustrated in Fig. 19.
Inner flange side Motor housing side
Inner flange side Motor housing side
Triangular
rule
Triangular
rule
Hex
wrench
2.5
Hex
wrench 2.5
Turn M5x8 Hex socket
head set screw at inner flange side.
Turn M5x8 Hex socket
head set screw at motor housing side
Thrust head
screw M5
Base complete
Blade case complete
Fig.17
Fig.18
Fig.19
Saw blade
(Horizontal line)
Lever 40 for
cutting depth adjustment
(Vertical line)
Saw blade
P
5
/
6
R
epair
Lever 30
for cutting
angle adjustment
