W
iring diagram
P 1
4/ 14
Connectors
Switch trigger
Switch
rib
FET
Brush holder complete
Light circuit
LED job light
90 degrees
Terminal
rib
Wiring in Housing (L) Complete
Fig. D-5
Top line of Switch
[Wrong]
[Correct]
LED job light
Lens of LED must be
parallel to the opening
of the LED mounting hole
in order to illuminate
worksurface exactly.
Worksurface
is bright.
Light
LED is unable to illuminate
worksurface if installed
upside-down.
LED job light
Worksurface
is dark.
Light
Note:
Install LED job light at the correct angle.
Connect Terminals from Brush holder
complete to Switch at the right angle
to the top line of Switch.
Do not put lead wires on this rib
to avoid pinching.
Fix Lead wires from
Connectors in these
Lead wire holders.
Route Lead wires from Switch
(black, red, white) through
the space between the rib and
Light circuit.
Fix the Lead wires of
LED job light in this
Lead wires holder.
