7
For tools which are equipped with a backing pad.
Installing or removing the wool pad
(optional accessory)
5
4
3
2
1
014936
To install the wool pad, first remove all dirt or foreign
matter from the backing pad. Press the shaft lock and
screw the backing pad onto the spindle. Insert the
sleeve 18 into the center hole of the backing pad.
Using the sleeve 18 as a positioning guide, install the
wool pad on the backing pad with the sleeve 18 inserted
through the center hole of the wool pad. Then remove
the sleeve 18 from the backing pad.
To remove the wool pad, just tear it off the backing pad.
Then unscrew the backing pad while pressing the shaft lock.
For tools which are equipped with a rubber pad.
Installing or removing the wool bonnet
(optional accessory)
3
1
2
4
5
014939
Mount the rubber pad onto the spindle. Screw the lock
nut onto the spindle.
1
2
014940
To tighten the lock nut, press the shaft lock firmly so that
the spindle cannot revolve, then use the lock nut wrench
and securely tighten clockwise.
To remove the rubber pad, follow the installation
procedure in reverse.
014941
Fit the wool bonnet over the rubber pad. Tie a bow knot
and tuck the knot and any loose strings between the
wool bonnet and the rubber pad.
Installing side grip (handle)
(optional accessory)
CAUTION:
•
Always be sure that the side grip is installed
securely before operation.
Screw the side grip securely on the position of the tool
as shown in the figure.
014943
OPERATION
Polishing operation
014937
CAUTION:
•
Always wear safety glasses or a face shield during
operation.
Hold the tool firmly. Turn the tool on and then apply the
wool pad/bonnet to the workpiece.
In general, keep the wool pad/bonnet at an angle of
about 15 degrees to the workpiece surface.
Apply slight pressure only. Excessive pressure will
result in poor performance and premature wear to wool
pad/bonnet.
1. Lock nut wrench
2. Shaft lock
1. Wool bonnet
2. Lock nut
3. Rubber pad
4. Spindle
5. Shaft lock
1. Wool pad
2. Sleeve 18
3. Backing pad
4. Spindle
5. Shaft lock
