Makita 6823, Instruction Manual

Page: 5 / 32

5
Hook
Fig.6
Fig.7
The hook is convenient for temporarily hanging the tool.
When using the hook, pull it out in "A" direction and then
push it in "B" direction to secure in place.
When not using the hook, return it back to its initial
position by following the above procedures in reverse.
ASSEMBLY
CAUTION:
•
Always be sure that the tool is switched off and
unplugged before carrying out any work on the
tool.
Installing or removing the bit
To remove the bit, first pull the locator out of the locking
sleeve. Then grasp the bit with a pair of pliers and pull
the bit out of the magnetic bit holder. Sometimes, it helps
to wiggle the bit with the pliers as you pull.
Fig.8
To install the bit, push it firmly into the magnetic bit
holder. Then install the locator by pushing it firmly back
onto the locking sleeve.
Fig.9
Installing removable cord adapter
For Model 6825R
Fig.10
Insert the Removable Cord Adapter as far as it goes so
that the marking
on an end of the Removable Cord
Adapter on the side of connecting to power supply cord
is aligned to the marking
on the other end of the
Removable Cord Adapter on the side of connecting to
the tool.
Turn the Removable Cord Adapter clockwise until it is
locked with a lock button.
Fig.11
And at this time the marking on an end of the
Removable Cord Adapter on the side of power supply
cord is aligned to the marking
on the other end of the
Removable Cord Adapter on the side of connecting to
the tool.
Fig.12
Removing removable cord adapter
Fig.13
Rotate the Removable Cord Adapter counterclockwise
until it stops while pressing the lower part of the lock
button.
Then pull the Removable Cord Adapter in that position.
Fig.14
OPERATION
Fig.15
Fit the screw on the point of the bit and place the point of
the screw on the surface of the workpiece to be fastened.
Apply pressure to the tool and start it. Withdraw the tool
as soon as the clutch cuts in. Then release the switch
trigger.
CAUTION:
•
When fitting the screw onto the point of the bit, be
careful not to push in on the screw. If the screw is
pushed in, the clutch will engage and the screw will
rotate suddenly. This could damage a workpiece or
cause an injury.
•
Make sure that the bit is inserted straight in the
screw head, or the screw and/or bit may be
damaged.
MAINTENANCE
CAUTION:
•
Always be sure that the tool is switched off and
unplugged before attempting to perform inspection
or maintenance.
To maintain product SAFETY and RELIABILITY, repairs,
carbon brush inspection and replacement, any other
maintenance or adjustment should be performed by
Makita Authorized Service Centers, always using Makita
replacement parts.
ACCESSORIES
CAUTION:
•
These accessories or attachments are
recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to persons. Only use accessory or
attachment for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
•
Phillips Insert bits
•
Magnetic bit holder
•
Locator
•
Plastic carrying case