P 5 / 12
R
epair
Retaining
ring S-42
Rubber sleeve 6
Pan head screw
M6 x 20
Safety cover
Tension spring 4
( 4 ) Assemble safety cover by holding with retaining ring S-42.
Assemble tension spring 4. (Hitch the end of tension spring on safety cover, and another end on blade case.)
Assemble rubber sleeve to blade case by screwing it with pan head screw M6 x 20.
Fig. 5
Correct assembling
to safety cover
Wrong assembling
to safety cover
* The tension spring 4 comes to
the blade installing side and interferes
with movement of the safety cover.
Blade installing
side
Motor side
Blade installing
side
Motor side
< Note in assembling >
Torsion spring
comes to the
space between
safety cover and
bearing box.
< 3 > Replacing armature and light unit (LED)
( 1 ) After disassembling safety cover, take off brush holder caps and carbon brushes as illustrated in Fig. 6.
And then take off 4 pcs. of countersunk head screws M5 x 12 which are screwed into base plate from its bottom
side for fastening angular guide. See Fig. 6 A.
4 pcs. of counter sunk head
screws M5 x 12
Bottom view of p base plate
Do not touch
this screw.
Brush holder cap
Carbon brush
Angular guide
Fig. 6
Fig. 6 A
Blade installing
side
Motor side
