MAKINEX MS-100
–
Operator’s
Manual
Page 14 of 16
13. Protool® Stirrer: Once equal consistency has
been achieved turn down Variable Speed Dial
to ‘1’ and switch ‘OFF’ Stirrer
at the Trigger.
Collomix® Mixer: Once equal consistency has
been achieved turn off the Mixer.
14. Unplug Stirrer/Mixer from Power Supply; wind-up the Power Cord on the MS-100Handle.
STEP 3
–
Pouring and Placing Levelling Compound
CAUTION
ALWAYS check that Power Cord is secured around the MS-100Handle
before Pivoting the Bucket.
CAUTION
NEVER place hand near the ‘Pivot Pin’
(Pivot Point) when rotating the
Bucket.
CAUTION
NEVER move or operate the fully loaded MS-100over an unstable surface.
CAUTION
ALWAYS protect open drains nearby from spillages of Compound
1. Check the
‘Locking Pin’ is engaged
(i.e. locked to prevent the bucket from pivoting) at the base of
the Bucket.
2. Disengage Castor Wheel Brake.
3. Wheel MS-100 to the desired area (use caution when moving the Loaded Bucket).
4. Disengage (unlock)
‘
Locking Pin
’
at the base of the Bucket.
5. Using a controlled motion
(use the ‘
MS-100 Handle and Pouring Handle) pour mixed Levelling
Compound where required.
NOTE:
With two MS-100 Portable Mixing Stations, another mix could be completed
using the same Stirrer/Mixer while one is being poured.
Trigger &
Trigger Lock
High / Low
Gear Selector
Trigger & Trigger Lock
High / Low
Gear Selector
Locking Pin
