MAKINEX MS-100
–
Operator’s
Manual
Page 13 of 16
STEP 2
–
Using your MS-100
WARNING
NEVER place hands into the Bucket whilst Stirrer/Mixer is Mixing.
ALWAYS disconnect Stirrer/Mixer from mains power before placing hands
into the Bucket.
WARNING
ALWAYS ensure the Stirrer/Mixer is switched OFF before plugging it in.
ALWAYS wind-up the Power Cord before moving the MS-100.
ALWAYS be aware of the Power/Extension Cord position when working
around the MS-100
™.
CAUTION
Maximum SAFE Load: 60-80kg (132-176lbs) of wet levelling compound.
DO NOT EXCEED 80kg (176lbs)
ALWAYS use correct lifting technique when loading materials.
1. Ensure Stirrer/Mixer is firmly secure in
the ‘Drill Clamp’
.
2. Attach Lid to Bucket.
3. Make sure the
‘
Locking Pin
’
is engaged (i.e. locked to prevent the bucket from pivoting) at
the base of the Bucket and that the Castor Wheel Brake has been applied.
4. Pour in correct amount of water for desired mix quality (refer to Levelling Compound
manufacturer’s recommendations)
.
5.
Protool® Stirrer:
Make sure Stirrer is
switched to
High Gear ‘2’
and Variable
Speed Dial is set to ‘1’
.
Collomix®
Mixer
: Make sure Mixer is
switched to low speed.
6. Plug in Stirrer/Mixer to Mains Power.
7. Press Trigger to turn
‘ON’
Stirrer/Mixer and lock in Trigger.
8. Start adding Bags of Levelling Compound one at a time.
9.
Protool® Stirrer:
After 2/3 of Levelling
Compound has been added to the mix
start to increase the Variable Speed Dial.
Collomix® Mixer:
Leave speed on low
setting.
10.
Protool® Stirrer:
After final Bag of
Levelling Compound has been added
turn Speed Dial to Maximum Power.
Collomix® Mixer:
After final bag of Levelling
Compound has been added switch drill to
high speed.
CAUTION
CAUTION
–
When changing gear settings on the Collomix® Mixer, turn the
Mixer off before changing the gear. Changing gears while the Mixer is running
may damage its gearbox.
NOTE:
After the final bag of Levelling Compound has been added, the whole mixing
operation should take approximately 2 minutes.
11. Wait for 30 seconds
as Compound is mixed; turn ‘OFF’
Stirrer/Mixer temporarily (Protool®
Stirrer: T
urn speed dial to ‘1’ before switching ‘OFF’
at the Trigger, then disconnect from
mains power) and scrape off any excess powder that has gathered around the top of the
bucket.
12. Switch Stirrer/
Mixer back ‘ON’ and return to Maximum Power unt
il Levelling Compound is
mixed to a lump-free consistency.
