4
MakerBot Replicator Mini
MakerBot
Step 5 - Remove the Housing
(optional)
Remove the following Screws:
two (2) button head Torx bolts by
using a T20 driver from the front
left and middle of the Inside Base.
eight (8) flathead bolts using a
2.5mm hex driver from the edges
of the Back Panel
one (1) tension bolt by using a
2.5mm hex driver from the Back
Panel.
three (3) button head Torx bolts
by using a T20 driver from the
Side Panels via the inside of the
printer.
two (2) button head Torx bolts by
using a T20 driver from the front
left and middle of the Inside Base.
one (1) lock washer nut and the
ground wire using a 7mm nut
drivert
four (4) button head Torx bolts by
using a T15 driver located on the
upper Inside Panels.
Unplug the Camera Wire at the
bottom of the Base from the
Queens PCB.
Remove the Gantry Belts from the
Gantry Pulley.
Loosen two (2) button head bolts
located on the left Gantry Motor
Mount (frame side).
Unplug Ribbon Cable at the
bottom of the base from the
Queens PCB.
•
•
•
•
•
•
•
•
•
•
•
•
