M
More Features
Note: For optimal cutting / engraving effect, it is recommended to use the Deli S550
oil-based marker, draw the image as far as possible from the ring code and the edge of the
material, and place the material in the center of the honeycomb panel. Only with copy
paper and official materials, you can bring sketch to life. Damages caused by the use of
other materials are not covered by Makeblock’s warranty service.
Bring sketch to life
Clean chippings
25
26
1
2
3
Residues and chippings
accumulated during operation
of the Laserbox should be
cleaned regularly, otherwise it
may cause a fire. Pull out the
tray as shown to clean up
residues and chippings.
Draw on copy paper or official
materials with a black/red oil-based
pen. For images drawn with a black
oil-based pen, the Laserbox will cut
along the contour and the black area
will be engraved. Images drawn with a
red oil-based pen will be cut directly
along the handwriting.
1. Draw an image, preferably with a
Deli S550 oil-based marker.
2. Place the material and close the lid.
3. Press the button on the Laserbox to
start the task.
