SL93 and SL68
Passive Infrared Light
Instruction
General:
The security light incorporates a PIR (Passive Infra Red)
sensing device which continuously scans a preset operating
zone and immediately switches the light on when it detects
movement in that area.
This means that whenever movement is detected within the
range of the sensor the light will switch on automatically to
illuminate pathways, steps, patios, porches, or whatever area
you have selected to light for reasons of safety, convenience or
security,
.
Function:
Can identify day and night automatically, the ambient-light
can be adjusted, so it works at night automatically and
stops in the daytime.
Time-delay can be adjusted varying with the place.
How to change into MANUAL CONTROL MODE:
1. When power on, the PIR detector enters into the “WARN –UP” period for about 1 minute, then
automatically changes into “AUTO MODE”.
2. During AUTO MODE, by switching off the ON/OFF main switch for about 4 seconds then switch on,
the PIR detector will automatically change into MANUAL MODE from AUTO MODE. In MANUAL
MODE, the lights will remain ON, not affected by duration time and Lux control level.
3. During MANUAL MODE or AUTO MODE, by switching off the ON/OFF main switch for over 30
seconds and then on again, the PIR detector will reset to “WARN-UP” periods.
Specifications:
Detection range: 180
°
Detection distance: 12m (<24
℃
)
Power source: 220 ~240V/AC
Time-delay: min 5sec
Max 7min
±
2min
Rated load: 150W
500W
Working temperature:-10
℃
~+40
℃
Working humidity: <93%RH
Ambient-light: <10Lux~2000Lux
Installation height: 2m~4.5m
Installation:
