Major tech MTC50, Instruction Manual

Page: 12 / 14

12
RJ45 jack on the master unit marked with a '
回
' and
the other end of the cable into the remaining receiving
RJ45 jack.
2. Slide power switch on. The upper row of LEDs will start
to scan in sequence if the Auto/Manual button is set on
"Auto" mode. The LED for pin 1 will light up if the button
is in "Manual" mode.
3. Switch back and forth from Auto or Manual scanning
mode by pressing the Auto/Manual button on the side of
the master-testing unit.
4. Once both ends of the cable are plugged in properly, the
second row of LEDs will illuminate according to the
corresponding LEDs in the top row.
5. Read the results of the LED display for the pin
configuration status of the tested cable. If you fail to
read the results the first time in Auto mode, you may
wait for the second LED scan, or simply switch to
Manual mode for pin by pin testing. In Manual mode,
pressing the square "Test" button will advance testing to
the next pin.
RJ11 Modular Cable Test
Please follow directions for the UTP/STP Cable Test and
use the operations manual for the correct LED pin out
display
Coaxial Cable Test
1. Plug the two attached BNC adapter cables on both
RJ45 jacks. Then connect the tested cable to each end
of the BNC adapter cables
2. For the remaining testing procedures, please refer to
10Base-T Test steps 2 to 5.
Note:
1. The center pin of BNC should be read on LED 2.