Tester Layout
1. LCD display
2. Select key: For ON/OFF, SELECT and OK
3. Up key: For upward selection and working mode switch
4. Clear Key: Calibration Zone of the FE and NFE
5. Housing
6. Back Key: For return or to delete the last measured data
7.
Down key: For downward selection or working mode switch
8. Probe
9. Battery cover
1
2
3
4
5
6
7
8
9
Power on:
Press and hold the POWER button. If the LCD display does not switch on,
check if the battery is correctly installed or flat.
Displayed:
Low battery, replace battery immediately. The gauge will take faulty
measurements if the voltage is low.
Note:
When the power is on, keep away from any metal at least 10cm away
before each measurement, zero calibration is recommended.
Ready to Start
1. Switch off the tester, remove the battery cover and remove batteries.
2. Insert new batteries, observing correct polarity and close the cover.
•
Replace the batteries when the symbol “
” is displayed.
.......
•
Use alkaline batteries only.
•
Remove the batteries before any long period of non-use to avoid the
danger of corrosion.
Inserting/Replacing Batteries
Function & Operation Instruction
•
Press the button to switch on the power. The gauge will automatically
O
work in measuring mode.
•
Press the
SELECT
button to enter the MENU mode.
