Tel44 (0) 8448 001 500
Fac44 (0) 1279 635 074
[email protected] www.majesticshowers.com
The Majestic Shower Company Limited
17 Flitch Industrial Estate, Chelmsford Road,
Dunmow, CM6 1XJ
Measure the glass door panel in mm and add 8mm (Xmm);
check that this is equal to the width of the aperture that the
door is to be fitted into.
Insert a black rubber hinge packer into the hinge cut outs, as
shown. Disassemble the hinges, being careful not to damage the
polished surfaces. Place the hinges and faceplates either side of
the hinge slots in the door, with gaskets inserted and Allen bolts
facing inwards; loosely screw the hinges and faceplates together.
Position the hinges at the top of their slots and use a set
square to the edge of the glass. The gaskets should be neat
and flush and the end of the glass should not protrude beyond
the hinges. Tighten the Allen screws.
Steps 4-6 require one person to support the glass
door panel at all times, while another person must be
inside the enclosure with hinge faceplates gaskets and screws.
Position the door mounting blocks on the tray or floor. Using the
suction glass lifters, lift the glass door panel onto the mounting
blocks. Be careful not to chip the edges of the glass against the
walls.
er
1
2
3
4