6
53D0419
Designer Series Gas Fireplaces
ELECTRICaL INSTaLLaTIoN
FP2551
remote switch wiring
REMoTE waLL MouNTED SwITCh
A remote wall switch and up to fifteen (15) feet of 18 Ga.
wire may be used with this appliance. Attach the wall
switch in a junction box at the desired location on the
wall.
Figure 39
. Do not extend beyond the wall switch wire
length provided.
w
a
RNING
Do not connect wall switch to (110 V)
circuit.
Figure 39 -
Wiring Diagram for Wall Switch
PILOT
HI
LO
ON
OFF
FP2919
DV wiring diagram
Piezo
Ignitor
Thermocouple
Sparker
Thermopile
Pilot
Assembly
Switch
ON
OFF
Millivolt
Valve
ON
OFF
Optional 15’
Wall Switch
FP919
REMoTE waLL SwITCh
Position the wall switch. Do not extend beyond the 15 feet
of wire.
oPTIoNaL DC REMoTE SySTEMS
These instructions replace the section entitled
Hearth
Mount
in the Millivolt hand held remote instructions sup-
plied with the remote.
Figure 40 -
Electronic Pilot Ignition Wiring
1. Plug in remote connector wire to remote receiver.
. Connect the wire terminal from the remote receiver. This
replaces the 15' wall switch connection to the switch.
Figure 40
3. Mount remote control receiver at junction box (for your
wall switch).
NoTE:
Extended lengths of wire may cause the fireplace
not to function properly. Longer length of wire is permitted
if the wire is made out of larger gauge (diameter) wire.
Always check with local code.
waRNING: Do not connect 110-120V
aC to the Remote wall Switch. The
appliance will malfunction.